SparkFun Accesorios SparkFun

Accesorios SparkFun SPDT Mini Power Switch

Accesorios SparkFun These are very bright LEDs. The LEDs are so bright that it hurts to look directly at them. Please take a look at the pictures to get an idea of the intensity. All lenses are clear.Features:Standard Size - T1 3/4 5mm10 000mcd brightness2.4V forward dr

Accesorios SparkFun This is a black plastic bezel custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. We use four 4/40-0.5" size screws matched with plastic standoffs to attach the 2x2 button pad and Simon project boards. Using two of these bezels

Accesorios SparkFun LEDs - those blinky things. A must have for power indication pin status opto-electronic sensors and fun blinky displays.This is a very basic 5mm LED with a yellow lens. It has a typical forward voltage of 2.0V and a rated forward current of 20mA.F

Accesorios SparkFun LED RGB Strip Addressable, 1m

Accesorios SparkFun USB Type 'A' Male connector. Ideal for making very small USB dongle devices that plug directly into a computer USB port or through a USB AtoA extension cable.Documents: Datasheet

Accesorios SparkFun Photo interrupter photogate photodiode phototransistor whatever you want to call it this sensor is composed of an infrared emitter on one upright and a shielded infrared detector on the other. By emitting a beam of infrared light from one uprigh

Accesorios SparkFun 2.4GHz Duck Antenna 2.2dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. 4" long. Not sure which RF connector you need on your antenna? Check out our RF Connector Guide

Accesorios SparkFun 900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units. 50 ohm impedance. 105mm long. Be sure to pick the antenna with the right connector. Almost all 2.4GHz and 915MHz antennas need to be RP-SMA.

Accesorios SparkFun This is a 1A Adjustable SOT-223 voltage regulator capable of outputting 1.2V to 18V. The LM1117 uses the same pin-out and setup as the popular LM317 adjustable regulator contained in a handy surface mount package. Requires two external resistors to

Accesorios SparkFun The MCP3002 has a 10-bit analog to digital converter (ADC) with a simple to use SPI interface. Use this IC if your microcontroller does not have an ADC or have enough ADC lines. A great chip when you need to add additional ADC lines.Features:2.7V to

Accesorios SparkFun This is a simple knob that connects to the extra large sized linear slide potentiometer. Each knob uses friction to secure itself to fit onto the slide pot. Once attached this small knob provides you with an easier to use potentiometer for your proj